To change that, add ntime parameter to node data.Ĭumulus Linux ran as a container might report errors related to DHCP client during initial configuration, in which case you might have to disable apparmor for DHCP client to get it to run. The default used by netlab is to run Cumulus Linux as a container. To change the default amount of memory used by a nxos device, set the parameter (in MB) 1Ĭontainerlab could run Cumulus Linux as a container or as a micro-VM with firecracker. Nexus OS release 10.2 requires at least 10 GB of RAM and crashes when ran as an 8 GB VM. Nexus OS release 10.1 requires 8 GB of RAM and will fail with a cryptic message claiming it’s running on unsupported hardware when it doesn’t have enough memory. Nexus OS release 9.3 runs in 6 GB of RAM ( netlab system default). CSR 1000v cannot be used as a router-on-a-VLAN-trunk device. VLAN subinterfaces can be configured on Cisco CSR 1000v but do not work. Maximum interface bandwidth on IOS XRv is 1 Gbps (1000000).Ĭisco CSR 1000v does not support interface MTU lower than 1500 bytes or IP MTU higher than 1500 bytes. Vagrant configuration file uses fixed SSH password. Earlier releases might use a different management interface name, in which case you’ll have to set _if parameter to the name of the management interfaceĬopying Vagrant public insecure SSH key into IOS XR during the box building process is cumbersome.
Netlab was tested with IOS XR release 7.4. Maybe I should do something on RouterOS if I want to run a zerotier docker in this way.Cisco IOSv release 15.x does not support unnumbered interfaces. Maybe I should have more modify on zerotier image before I could use it in this way.Ģ. I don't know how the official zerotier docker image will handle it.ġ. But the difference is snell docker will masq all traffic. Which means my RouterOS config probably is fine. I could successfully replicate my expectation using another Docker image utilize snell protocol. I could ping it from a different zerotier network node. I followed the MikroTik's container instruction, and used official zerotier docker in a slightly different way.Īfter the container is running, the () successfully recognized it. For example, on the official zerotier docker instruction, ``` However, using docker on RouterOS is the only way. I am using ZeroTier on all my MikroTik devices.
0 kommentar(er)
